Re-entering Setup

 

Any time that you exit the Program Security Setup dialog box after designating the <Supervisor> Program Security function as protected, you will need to use your master password to get back into Program Security Setup. 

To enter Program Security after it has been protected:

1. Select Program Security from the Setup menu.

The Password Validation dialog box requires that you enter a password. 

2. Enter the master password that you designated when you set up protected areas (refer to Setting Up Protected Functions , if necessary).

3.  Select OK.

The Program Security Setup dialog box appears.

The system functions that have been designated as protected display in the Select Protected Areas portion of the dialog box.